3800 SuperCharged engine installed in your V6 Fiero

OBDII programming now available: See this page > http://www.fastfieros.com/obdii_programming.htm <

This is the basic install with upgrades available. Custom OBDII programming for your Fiero is FREE with the turnkey install. 6 months of FREE updates after you get your car back.

$8800 gets you this > 85-88 V6 automatic to 97-03 V6 3800SC automatic

The engine Series II - I use 30kish OR less mileage engines for all my installs
The transmission - I use the 4T65eHD with the same 30kish OR less mileage
The axles - I custom configure the 4T65 trans axles to the Fiero bearing hubs (right side)
The fuel system - Upgraded fuel pump installed on all Fieros
The PCM - I use OBDII 97-03 PCM's only for Series II installs
VATs is now programmed OUT, no module to worry about burning out in the middle of nowhere.
ALL codes removed for any OBDII testing via smog check, tuned ONSITE only for this feature.
The wiring - I custom wire the harness from the 3800SC cars and Fiero
The mounting - I use only PolyUrethane mounts in the engine and transmission
The exhaust - I use the STOCK 3800SC exhaust with a Y-collector into small mufflers, to the tips
The AC - Working AC R134 on all installs
Breather for venting engine to avoid future oil leaks
The instrument panel - I provide all working gauges (Speedo, Tach, oil pressure and water temp)
All miscellaneous > clamps, hoses, wires, plugs, welding, cleanup, painting, labor for remove and replace engine/trans, and other small items.

Pictures of previous installs:

$8800 gets you this > 85-88 V6 manual to 97-03 V6 3800SC manual

The engine - I use 30kish mileage engines for all my installs
The transmission - I use the Fiero transmission
The clutch package - custom flywheel, custom 9 11/16ths disc and plate, new bearing
The drive axles - The Fiero axles are used in this installation
The fuel system - Upgraded fuel pump installed on all Fieros
The PCM - I use OBDII 97-03 PCM's only for Series II installs
VATs is now programmed OUT, no module to worry about burning out in the middle of nowhere.
ALL codes removed for any OBDII testing via smog check, tuned ONSITE only for this feature.
The wiring - I custom wire the harness from the 3800SC cars and Fiero
The mounting - I use only PolyUrethane mounts in the engine and transmission
The exhaust - I use the STOCK 3800SC exhaust with a Y-collector into small mufflers, to the tips
The AC - Working AC R134 on all installs
Breather for venting engine to avoid future oil leaks
The instrument panel - ALL working gauges (Speedometer, Tach, oil pressure and water temp)
All miscellaneous > clamps, hoses, wires, plugs, welding, cleanup, painting, labor for remove and replace engine/trans, and other small items.

ADD $ for Series III engines

ADD $ for Electronic Throttle Control systems

ADD $ for TAP shift FR9 transmissions

ADD $ for PASSKEY 3+ systems

Pictures of previous installs http://www.fastfieros.com/projects 

Read all about GM PowerTrain engines here >>
http://www.gm.com/automotive/gmpowertrain/engines/gmpow/l67.htm